Testing & Measuring l Trulok Gages l Hole Diameter Gages l Top Edge SR900-EH-XX

A high precision digital gage for quick and accurate measurement of the hole diameter (at the entrance/ exit). This gauge contacts the edge of the hole diameter at two opposite (180°) positions. This conical blade configuration probe is designed to measure a large range of diameters and establish the form of the hole. The standard measuring range of this gage is from .080 to .312 inch. Gages with other ranges and base configurations can be built per customer's specifications.

Features:
• Measuring accuracy .00025 inch (.006mm)
• Direct contact on the major hole diameter
• Direct reading, no calculations or charts necessary
• Large base configurations available for curved surfaces
• Accurate, repeatable and reproducible
• SPC ready via data port cable
• Ease of use with minimal training
• Eliminate costly rework
• Gage and set block calibrated to NIST traceable standards
• Unique serial numbers on gages, set blocks and indicators
• The components of our gages are made of heat treated wear resistant tool steels and micro finished to ensure accurate and trouble free operation
• LCD display with rotating bezel
• Inch/ mm mode toggle capable
• SPC data output ready via data port
• Upper and lower tolerance capable
• User selectable resolution (Mahr-Federal)
• Auto power off after 15 minutes of inactivity (Mahr-Federal)
• Lockout of setup preset (access key – Mahr-Federal, computer -Mitutoyo)
• Choice of indicators: Mahr-Federal or Mitutoyo (please advise of your preference